iRubric: Metal Project rubric

(draft) edit print share Copy to my rubrics Bookmark test run assess... delete Do more...

Metal Project

Student must follow given directions to create a metal piece with percise measurments using a long list of hand tools and a few power tools

Rubric Code: JX444CX

By ecruzauto

Draft

Public Rubric

Subject: Vocational

Type: Assessment

Grade Levels: 9-12

Metal Project
	Poor 15 pts	Fair 25 pts	Good 33.3 pts
Correct Measurements	Poor The student was above a 1/2 inch of the required measurement 1.5 inches for width and 2.5 inches for height. Student cut below the desired measurement anywhere on the project.	Fair The student was below a 1/4 inch of the required measurement 1.5 inches for width and 2.5 inches for height. Student did not cut below the desired size in any area of the project.	Good The student was below a 1/32 inch of the required measurement 1.5 inches for width and 2.5 inches for height. Student did not cut below the desired in any area
The feel of the metal	Poor Student did not file most the project to remove burrs from cutting with hacksaw.	Fair Student filed some areas of project, but still has areas that needed more work done.	Good Students filled all areas down to a smooth finish. There is not area that drags your fingers during inspection.
Different holes drilled	Poor Student used the same drill to make holes or did not use a center punch to start drilling.	Fair Student used 2 types of drills to make holes into project.	Good Students used all 3 types of drills to make holes as directed, also used center punch to start holes with drill bits.