iRubric: Bending an Offset rubric

edit print share Copy to my rubrics Bookmark test run assess... delete Do more...

Bending an Offset

Using a 5' length of 1/2" EMT, make an offset to clear a 5" obstruction. Neither bend is critical. Be sure to ream the cut end of the conduit.

Rubric Code: J25XB56

By mstowne

Ready to use

Public Rubric

Subject: Vocational

Type: Assessment

Grade Levels: 9-12

Conduit Bending
	Good 4 pts	Excellent 5 pts	Fair 3 pts	Poor 2 pts
Reamed and 5' in length	Good Cut end was properly reamed and conduit was within 1/4" of 5'	Excellent Cut end was properly reamed and conduit measured 5'	Fair Cut end was properly reamed and conduit was within 1/2" of 5'	Poor Cut end was not reamed and conduit was more than 1/2" of 5'
Offset Measurements	Good 1st and 2nd marks were within 1/4" of being correct	Excellent 1st and 2nd marks were both correct	Fair 1st and 2nd marks were within 1/2" of being correct	Poor 1st and 2nd marks were more than 1/2" of being correct
Quality of Bend	Good Bends were smooth, in line, and within 1/2" of desired measurement	Excellent Bends were smooth, level, and in line	Fair Bends were smooth, in line, and within 1" of desired measurement	Poor Bends were smooth, had a dog leg, and more than 1" of desired measurement
Bending Technique	Good Bending technique was good	Excellent Proper bending technique was used	Fair Bending technique was fair	Poor Bending technique was poor
Safety/PPE	Good Work was performed in a safe manner but PPE was not worn throughout	Excellent Work was performed in a safe manner and proper PPE was worn	Fair PPE was worn but work was not performed in the safest manner	Poor Work was not performed safely and no PPE was worn